Steady CFD Simulation of a High Pressure Turbine Rotor With Hub and Shroud Purge Flow

Abstract

Purge air is injected at the hub and shroud of axial turbines in order to avoid hot gas entering the gaps between stationary and rotating blade rows. The purge flows considerably interact with the main flow and influence the secondary flow like the tip leakage vortex. Therefore, at Graz University of Technology the flow in a product-representative one-and-a-half stage test turbine under the influence of purge flows was investigated. Four individual purge mass flows differing in flow rate, pressure, and temperature were injected through hub and tip cavities before and after the unshrouded high-pressure turbine rotor. In order to get more insight into the cavity flows and the flow evolution in the rotor this configuration is studied with a steady CFD simulation with and without purge flows. It was found that the secondary flow and especially the tip leakage vortex is significantly influenced by the purge flow which varies in circumferential direction. The differences between purge and zero-purge flow conditions are discussed with the help of radial distributions and contour plots of stream-wise vorticity. Streamlines allow to follow the path of the purge flows in the rotor and show the radial displacement of the secondary flow vortices. Wall streamlines describe the changes in the boundary layer flow and their effect on the vorticity after the trailing edge.