Abstract
This paper focuses on two forced convection methods—steady jet flow and pulsating flow by synthetic jets—that can be used in applications requiring significant amounts of heat removal from electronics components. Given the dearth of available data, we have experimentally investigated steady jets and piezoelectrically driven synthetic jets that provide pulsating flow of air at a high coefficient of performance. To mimic a typical electronics component, a 25.4-mm × 25.4-mm vertical heated surface was used for heat removal. The impingement heat transfer, in the form of Nusselt number, is reported for both steady and unsteady jets over Reynolds numbers from 100 to 3000. The effect of jet-to-plate surface distance on the impingement heat transfer is also investigated. Our results show that synthetic jets can provide significantly higher cooling than steady jets in the Reynolds number range of 100 to 3000. We attribute the superior performance of synthetic jets to vortex shedding associated with the unsteady flow.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.