Abstract
With the introduction of 0.18 micron CMOS process technology a new phenomenon in circuit manufacturing can be observed: design-rule values as specified in the design-rule manual are no longer “hard” numbers. Where designers and EDA tool manufacturers used to consider rule-values as strict limits when creating mask layouts, rule values have turned into gray areas around the specified rule values. This concept is illustrated in the following figure:
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
