Abstract
The computer program STGAP has been developed to estimate pin gaps in a fuel assembly for FUGEN. The program optionally computes the probable distribution of the pin gap between any adjacent pair of fuel pins, either at a desired location in an assembly or longitudinally averaged over the total effective length of a pin, based on the measured manufacturing and assembling tolerances in geometrical dimensions and mechanical properties of all the independent elements composing a fuel assembly. It also correlates the computed fuel gap distribution with the minimum critical heat flux ratio in the corresponding local subchannel. Sample calculations were performed for the probable distributions of the pin gaps between pairs of adjacent fuel pins in the outermost layer of a FUGEN fuel assembly using the program and satisfactory agreement was obtained with the corresponding measured distributions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
