Abstract

A method for space power system state estimation from real-time measurements is presented. When the online measurement set includes voltage magnitude plus real and reactive power injections at each bus, a single matrix inversion directly yields the state of the power system without iteration. The calculated state is dependent on the error tolerance of the physical measurements. When the voltage magnitude at the buses is unknown, but real and reactive bus power injections are specified or measured, the method is used for an iterative power flow calculation. The updated value of the state vector is used in the matrix inversion of the next iteration. The strong convergence of the load flow method is shown for several standard IEEE test cases. >

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.