Abstract

In synthetic aperture radar (SAR) imaging, geometric resolution, sidelobe level (SLL) and signal-to-noise ratio (SNR) are the most important parameters for measuring the SAR image quality. The staring spotlight mode continuously transmits signals to a fixed area by steering the azimuth beam to acquire azimuth high geometric resolution, and its two-dimensional (2D) impulse response with the low SLL is usually obtained from the 2D weighted power spectral density (PSD) by the selected weighting window function. However, this results in the SNR reduction due to 2D amplitude window weighting. In this paper, the staring spotlight SAR with nonlinear frequency modulation (NLFM) signal and azimuth non-uniform sampling (ANUS) is proposed to obtain high geometric resolution SAR images with the low SLL and almost without any SNR reduction. The NLFM signal obtains non-equal interval frequency sampling points under uniform time sampling by adjusting the instantaneous chirp rate. Its corresponding PSD is similar to the weighting window function, and its pulse compression result without amplitude window weighting has low sidelobes. To obtain a similar Doppler frequency distribution for low sidelobe imaging in azimuth, the received SAR echoes are designed to be non-uniformly sampled in azimuth, in which the sampling sequence is dense in middle and sparse in both ends, and azimuth compression result with window weighting would also have low sidelobes. According to the echo model of the proposed imaging mode, both the back projection algorithm (BPA) and range migration algorithm (RMA) are modified and presented to handle the raw data of the proposed imaging mode. Both imaging results on simulated targets and experimental real SAR data processing results of a ground-based radar validate the proposed low sidelobe imaging mode.

Highlights

  • High geometric resolution, low sidelobe level (SLL), and high signal-to-noise ratio (SNR) have always been pursued in synthetic aperture radar (SAR) data acquisition and imaging processes [1,2,3]

  • The spotlight SAR, including sliding spotlight and starring spotlight modes, can achieve high-resolution imaging via azimuth beam steering from fore to aft during the whole SAR acquisition interval, and the azimuth resolution is determined by the azimuth beam steering capacity [4,5,6]

  • The starring spotlight mode has been practically applied in the TerraSAR-X satellite, which can improve the azimuth resolution to about 0.2 m [7,8]

Read more

Summary

Introduction

Low sidelobe level (SLL), and high signal-to-noise ratio (SNR) have always been pursued in synthetic aperture radar (SAR) data acquisition and imaging processes [1,2,3]. The sampling points at the center of the synthetic aperture time are denser, and the sampling points in both sides are sparse This sampling behavior means that the Doppler frequency will change slowly in the middle and fast in both sides, which is similar to the NLFM generation. To obtain such a Doppler frequency sampling distribution for all targets in the imaged scene, each target should have the same start and end time of the synthetic aperture, and the starring spotlight mode meets with this requirement.

NLFM Signal and Azimuth Non-Uniform Sampling
Azimuth Non-Uniform Sampling
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call