Stand-Alone Large Bore Aspiration Catheter (0.072 Inch) for Both Guide Support and Clot Aspiration in Transradial Posterior Circulation Stroke Thrombectomy: Technical Series.

Abstract

The large size of guide catheters in the traditional triaxial configuration can prove limiting during transradial vertebrobasilar thrombectomy. This is especially important for the direct aspiration technique because of the large aspiration catheters that can reach an inner diameter of 0.072 in. A strategy that strikes a balance between stable proximal vessel support and distal navigation for aspiration is conceptually attractive. To describe a series of transradial posterior circulation thrombectomy procedures in which the aspiration catheter served a dual role of guide support and clot aspiration in a coaxial configuration, thus obviating a larger guide catheter. Patients selected in the series underwent radial artery access and direct over-the-wire navigation of the aspiration catheter into the vertebral artery. With coaxial microcatheter navigation, the aspiration catheter reached distal enough to ingest the clot successfully. Along with clinical and angiographic data, imaging features such as angle of vertebral artery origin were calculated. Five patients underwent a stand-alone aspiration catheter technique for basilar artery occlusion through transradial access. All procedures resulted in thrombolysis in cerebral infarction 3 recanalization. The mean time to basilar artery recanalization was 10 minutes. No access site complications or vertebral artery dissection were noted. The mean subclavian artery-vertebral origin angle was 84.06° (range 78.2-90.2°). For patients selected properly based on vascular anatomy and a careful technique, a large bore aspiration catheter can fulfil a stand-alone dual-role, thus obviating the need for a guide catheter. This can potentially improve the technical feasibility and success of transradial vertebrobasilar thrombectomy.