Stabilization of Platinum Catalyst Surface-Treated by Atomic Layer Deposition of Cobalt for Polymer Electrolyte Membrane Fuel Cells

Abstract

Listen

Translate article

Polymer electrolyte membrane fuel cells (PEMFCs) are attracting attention as next-generation energy-conversion devices because they are environmentally friendly and have high energy-conversion efficiencies. A membrane electrode assembly (MEA), composed of an anode, membrane, and cathode, is the most important part of a PEMFC where electrochemical reactions occur. A Pt/C catalyst, wherein Pt is supported on a carbon, is used as the catalyst layer for the anode and cathode. However, as Pt is a precious metal, current research is focused on reducing its loading and improving durability of PEMFCs. This study focused on improving the durability of catalysts by suppressing agglomeration, one of the degradation mechanisms of Pt catalysts. A protective layer of Co metal was deposited using the atomic layer deposition (ALD) process to improve the durability of catalysts. The ALD process is a type of chemical vapor deposition (CVD) process. This process is suitable for the PT/C catalyst as it allows for the deposition of a uniform thin film even on the porous catalyst layer. If the protective layer is thick, it may block the active site of the catalyst, resulting in decreased activity and reduced performance. However, ALD can form a thin protective layer because it can be controlled at the atomic level by adjusting the number of cycles. After fabricating a single cell using ALD Co-Pt/C as a catalyst for the cathode, The U.S. Department of Energy's electrocatalyst durability protocol was used for an accelerated degradation test (ADT). After Co-ALD was used as a cathode for 10 and 20 cycles, the active area of the Pt catalyst particles was reduced owing to the metal Co protective layer. The initial performance and electrochemical surface area (ECSA) of Co-ALD 10, 20 cycles decreased compared to the case of using Co-ALD 0 cycle. However, after ADT, the performance and ECSA reduction rate rather decreased, confirming that the co-protective layer through the plasma-enhanced atomic layer deposition (PEALD) process can improve the durability of the Pt/C catalyst. To identify the cause of the durability improvement, the cathode catalyst particles before and after ADT were compared through high resolution transmission electron microscopy (HR-TEM) analysis. As a result, in the HR-TEM images after ADT, the Pt catalyst particles were relatively uniformly distributed on the carbon support in the Co-Pt/C catalyst compared to Co-ALD 0 cycle. In addition, it was confirmed that the size of the Pt catalyst particles of Co-Pt/C was smaller than that of bare Pt/C (Co-ALD 0 cycle). It was concluded that when the Co protective layer was deposited on the Pt/C cathode, the protective layer suppressed the agglomeration of Pt catalyst particles, therefore, the increase in Pt particle size improved compared to the Co-ALD 0 cycle, and it was revealed that durability improved by suppressing catalyst degradation.