Abstract
The performance of high-density cubes in the armor layer of a breakwater was investigated through an experimental study. For this purpose, two different cross-sections, one with a conventional cross-section and one with a berm, were modelled in a wave flume. A total of ten tests were performed for both cross-sections. Different concrete densities of cubes and different placement methods were applied. The dimensions of the cubes with two different densities were the same for all tests to avoid potential scale effects caused by the dimensions of HD cubes. The experimental study showed that HD cubes were more stable than ND cubes; the characteristic wave height for HD cubes was 1.5 times higher than that of the ND cubes. The use of HD cubes may provide economic efficiency and enables a significant reduction of the concrete volume, transportation of material, and reduction of required construction area for manufacturing, etc. HD cubes in a single layer turned out to be very stable. However, only using HD cubes in a part of the armor layer or only used on the second (upper) layer caused a decrease in the stability of the armor layer, especially in comparison to the armor layers that fully consist of HD cubes. The performance of HD cubes was also evaluated by comparing the experimental results with the Van der Meer (1988) formula and the suitability of the stability number for HD cubes was discussed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
