Stability of Freeze-Dried Tablets at Different Relative Humidities

Abstract

The purpose of the study was to evaluate the stability of two different freeze-dried tablet formulations at different relative humidities (RHs). The tablets contained 25 mg hydrochlorothiazide (HCT) as a model drug and were prepared by freeze-drying a suspension and an oil-in-water (o/w) emulsion. Formulation A was a rapidly disintegrating tablet and consisted of 80 mg of maltodextrine DE38; 8 mg of polyethyleneglycol (PEG 6000), 8 mg of xanthan gum, and 25 mg of HCT. Formulation B was a lyophilized dry emulsion tablet that consisted of 160 mg of Miglyol® 812, 80 mg of maltodextrin DE38, 16 mg of methylcellulose (Methocel®) A15LV, and 25 mg of HCT. Tablets were packaged in different packing materials: polyvinylchloride (PVC)/aluminum blister packs, PVC-polyvinylidenechloride (PVDC)/aluminum blister packs, closed containers with a dessicant tablet, and open containers. The tablets were stored at three relative humidities (45%, 60%, and 85% RH) and were characterized on mechanical strength, residual moisture, porosity, content uniformity, and scanning electron microscopy (SEM) during a period of 6 months. After 1 month at 60% and 85% RH, a strong increase in moisture content (from 2.7% to 6.8%) was seen for the tablets packed in the open and closed containers and for the PVC/aluminum blistered tablets. This increase was higher for formulation A compared to formulation B since B contained 160 mg of triglycerides and was more hydrophobic. This increase in water content was correlated with a decrease in mechanical strength. The tablets also showed a change in microstructure and porosity. At a moisture content of 7.2%, formulation A showed a structural “collapse” since water acts as a plasticizer for the amorphous glass, lowering the glass transition temperature Tg. This phenomenon even occurred in PVC/aluminum blister packs at 85% RH. The structural collapse was associated with a complete loss of microstructure as detected by porosimetric analysis and SEM. For the PVC-PVDC/aluminum blistered tablets, the increase in moisture content and decrease in mechanical strength at 85% RH occurred much slower, and the water uptake and strength loss were less intensive. No significant breakdown of HCT could be observed in both formulations with all of the packing materials. Packaging of freeze-dried tablets with PVC/aluminum blister packs, PVC/PVDC/aluminum blister packs, or closed containers did not offer protection against moisture uptake, mechanical strength loss, and structural collapse.