Abstract
A stability-indicating reverse phase-high-perfromance liquid chromatography method for the quantitative determination of dimethyl fumarate in presence of its main degradation products was developed. The chromatographic conditions were optimized using two-level full factorial design, chromatographic analysis was performed using Inertsil® column (250×4.6mm, 5μm) maintained at 25°C. Mobile phase was a mixture of water (pH 2.6 adjusted with phosphoric acid) and methanol (40:60, v/v) at a flow rate 1.0mL/min, detection was performed at 210nm using diode array detector. Stress degradation of dimethyl fumarate under acidic, alkaline, neutral, oxidative, photolytic, and thermal conditions was carried out, it was found to be very susceptible to hydrolysis under acidic and alkaline conditions; further investigation of degradation kinetics over pH range 1-9 was carried out. The degradation rate constant (K), t1/2 and t90 were calculated. Dimethyl fumarate show decreasing in stability in the following pH order: 7<5<3<1<9. The method was validated as per ICH guidelines, the method was found to be linear over concentration range 10-150μg/mL with coefficient of determination (r2 ) 0.9997. The method was successfully applied for dimethyl fumarate determination in Marclerosis® dosage form within run time less than eight minutes without interference from excipients.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.