Abstract

AbstractOne of the main causes of the degradation of organic solar cells is the interface between the indium tin oxide (ITO) anode and the poly (3,4-ethylendioxythiophene):poly (styrenesulfonate) (PEDOT:PSS) hole transport layer (HTL), which is known to be unstable. On the contact surface, corrosion of the ITO is induced by PEDOT:PSS, and this degrades the performance of the device. In this paper, we solve this problem by introducing an inorganic HTL, nickel oxide (NiO), between the ITO and the active layer. Solution process, a low-cost production method for preparing thin films, is employed to fabricate the NiO HTL for organic solar cells based on poly (3-hexylthiophene) (P3HT) and [6,6]-phenyl C61-butyric acid methyl ester (PCBM). The performance of the resulting organic solar cells is optimized by modifying the baking conditions of the NiO thin films, yielding a power conversion efficiency enhancement of 1.97% and fill factor of 52.11%. Moreover, a remarkable improvement in cell lifetime is observed. X-ray photoelectron spectroscopy studies show that cell performance and stability strongly depend on the oxygen composition ratio of the NiO structure. The transition of the O2− ratio is a key factor that determines the conductivity of NiO. These results compare favorably with those reported in the literature for conventional devices with PEDOT:PSS.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.