Abstract
Thermoelastic deformation of rock significantly affects the stability of rock slope because thermoelastic strains may cause fracture propagation under favorable condition of failure. Rock slope stability depends on the balance between shear stress and shear resistance along the plane of weakness. Due to warming of rock slopes by heat transfer phenomena, viz. conduction and convection, considerable change in induced stresses (normal and shear) and resistance takes place which further causes instability in rock slope. In this paper, a two-dimensional finite element model has been used to simulate the stability of jointed rock slope containing crack in its upper surface. Four different cases have been simulated on the basis of infilling material (air, water, ice, water and ice) in the crack. Stability of rock slope is examined in terms of shear displacement and factor of safety for different thermal conditions of slope surface. A comparative study has been done for the four cases of infilling material in the crack. The various affecting parameters, viz. shear displacement, factor of safety, shear strength along the joint, and different surface temperature conditions, are illustrated by means of graphs. It has been found that the values of horizontal and vertical displacements are in the range of millimeters. The maximum values of horizontal and vertical displacements are 2.17 mm. Moreover, the maximum values of vertical compressive and tensile stresses are 15.4 MPa and 4.45 MPa respectively for the said four cases. According to the infilling material in the crack, the stability of the rock slope for the given geometry of slope is found in the following order: crack filled with ice < crack filled with ice and water < crack filled with water < empty crack. Validations of numerical results have been done from previous studies, and it has been found that the trends of normal stress, shear strength, and shear displacement along the joint are well matched.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
