Abstract
Objectives: Correct sprue design is a major factor in the reduction of defects in castings of cobalt-chromium alloy. The purpose of this study was to investigate the sprue arrangements decided by a group of dental technicians, for a series of proposed removable partial denture castings, in order to determine if there was any consistency between them which would suggest the application of criteria in their design. Methods: Information was gathered by postal inquiry with recipients asked to indicate their sprue designs on diagrams of patterns for proposed cobalt-chromium partial denture castings. Results: Replies were received for 260 proposed castings from dental schools, technical colleges and commercial laboratories which gave an overall response rate of 52%. Results displayed a wide range of responses in relation to sprue number and dimension, attachment site and the intended direction of metal flow. Conclusion: It was concluded that the group of technicians studied arbitrarily chose sprue arrangements for the castings proposed rather than following definite design criteria that seek to minimize potential problems during casting procedures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.