Sprayed glass fibre reinforced polymer masonry columns under concentric and eccentric loadingThis article is one of a selection of papers published in this Special Issue on Masonry.

Abstract

Strengthening masonry columns by spraying them with glass fibre reinforced polymer (GFRP) was investigated experimentally. The study was aimed at assessing the strength and strain increases imparted by the technique under both concentric and eccentric axial loading. Plain and steel-reinforced columns were tested. Twenty-four columns were constructed from Type S mortar and straight and bullnose clay masonry units. The columns were 1 m high and either 290 mm × 290 mm or 390 mm × 390 mm in cross section. Two thicknesses of sprayed GFRP (SGFRP) were attempted, but it was found to be difficult to maintain uniform thickness. Nevertheless, with only minor increases in strength, large increases in strain capacity were achieved with both the plain and reinforced columns under concentric axial compression. Eccentric loading reduced the effect of the SGFRP laminate on the strength of masonry columns. Failure of SGFRP included both mode I and mode III fractures.