Spray-dried whey protein/lactose/soybean oil emulsions. 1. Surface composition and particle structure

Abstract

Emulsions made of whey protein, lactose and soybean oil were spray-dried and the chemical surface composition of the dried powders estimated by electron spectroscopy for chemical analysis. In particular, the ability of whey protein to encapsulate fat was highlighted. Additionally, the structure of the spray-dried powder particles was studied by scanning electron microscopy. The powders were examined after storage in both dry and humid atmospheres (relative humidity 75%, 4 days). It was found that the ability of whey protein to encapsulate soybean oil is rather low compared with sodium caseinate, with a large part of the powder surface covered by fat after spray-drying. After storage in humid atmosphere there is a release of encapsulated oil onto the powder surface in most cases, and an increase in fat coverage. The release offat onto the powder surfaces causes the particle structure to change dramatically for powders containing a critical amount of lactose. Such powders agglomerate and lose structure completely. In comparison, powders containing no lactose storage under humid conditions also cause a release of fat onto the powder; however, in this case particle structure remains intact. Powders containing only a small amount of lactose, up to ~25% of emulsion dry weight, do not exhibit the release of fat onto the powder surfaces after storage under humid conditions and the structure of these powder particles does not change. The presence of lactose in whey protein-stabilized emulsions, however, does not increase fat encapsulation by whey protein, as reported earlier for sodium caseinate-stabilized emulsions that were spray-dried. During spray-drying of whey protein/lactose solutions there is a strong overrepresentation of surface-active whey protein on the powder surface. Whey protein coverage increases even further when the powders are stored under humid conditions, also making them lose structure.