Spray Drying Performance of a Laboratory Spray Dryer for Tomato Powder Preparation

Abstract

This work investigates the performance of a spray dryer for tomato powder preparation by spray drying of tomato pulp. Samples of tomato pulp with a 14% constant total solids concentration were used, and a pilot scale spray dryer (Buchi, B-191) with cocurrent operation and a two-fluid nozzle atomizer was employed for the spray drying process. Twenty-four different experiments were conducted keeping constant the feed rate, the feed temperature, and the atomizer pressure, and varying the compressed air flow rate, the flow rate of drying rate, and the air inlet temperature. In each experiment the air outlet temperature was recorded. Data for the residue remaining in the chamber and cyclone walls was gathered and two types of efficiencies were calculated as an indication of the spray dryer performance. Analysis of experimental data yielded correlations between residue accumulation and the variable operating conditions. The same operating parameters had a great influence on the air outlet temperature whereas temperature deviations were observed comparing measured air outlet temperatures with corresponding outlet adiabatic saturation temperatures.