Abstract

The technique of laser ablation in liquids (LAL) has already demonstrated its flexibility and capability for the synthesis of a large variety of surfactant-free nanomaterials with a high purity. However, high purity can cause trouble for nanomaterial synthesis, because active high-purity particles can spontaneously grow into different nanocrystals, which makes it difficult to accurately tailor the size and shape of the synthesized nanomaterials. Therefore, a series of questions arise with regards to whether particle growth occurs during colloid storage, how large the particle size increases to, and into which shape the particles evolve. To obtain answers to these questions, here, Ag particles that are synthesized by femtosecond (fs) laser ablation of Ag in acetone are used as precursors to witness the spontaneous growth behavior of the LAL-generated surfactant-free Ag dots (2–10 nm) into different polygonal particles (5–50 nm), and the spontaneous size separation phenomenon by the carbon-encapsulation induced precipitation of large particles, after six months of colloid storage. The colloids obtained by LAL at a higher power (600 mW) possess a greater ability and higher efficiency to yield colloids with sizes of <40 nm than the colloids obtained at lower power (300 mW), because of the generation of a larger amount of carbon ‘captors’ by the decomposition of acetone and the stronger particle fragmentation. Both the size increase and the shape alteration lead to a redshift of the surface plasmon resonance (SPR) band of the Ag colloid from 404 nm to 414 nm, after storage. The Fourier transform infrared spectroscopy (FTIR) analysis shows that the Ag particles are conjugated with COO– and OH– groups, both of which may lead to the growth of polygonal particles. The CO and CO2 molecules are adsorbed on the particle surfaces to form Ag(CO)x and Ag(CO2)x complexes. Complementary nanosecond LAL experiments confirmed that the particle growth was inherent to LAL in acetone, and independent of pulse duration, although some differences in the final particle sizes were observed. The nanosecond-LAL yields monomodal colloids, whereas the size-separated, initially bimodal colloids from the fs-LAL provide a higher fraction of very small particles that are <5 nm. The spontaneous growth of the LAL-generated metallic particles presented in this work should arouse the special attention of academia, especially regarding the detailed discussion on how long the colloids can be preserved for particle characterization and applications, without causing a mismatch between the colloid properties and their performance. The spontaneous size separation phenomenon may help researchers to realize a more reproducible synthesis for small metallic colloids, without concern for the generation of large particles.

Highlights

  • Laser ablation in liquids (LAL) is increasingly gaining worldwide attention as a newly emerging bottom-up and top-down combined technique for novel nanomaterial synthesis, offering diverse applications including optics and biology [1,2,3,4]

  • No attempt has been made to study the growth of the metallic particles just after laser irradiation, which occupies the dominant position in all three liquid-phase laser synthesis methodologies, LAL, laser fragmentation in liquids (LFL), and laser melting in liquids (LML) [1]

  • It has been reported that the redshift of the surface plasmon resonance (SPR) peaks for the Ag NPs is often indicative of an increase of the particle size [37] via either particle ripening or coalescence, giving indirect evidence for particle growth

Read more

Summary

Introduction

Laser ablation in liquids (LAL) is increasingly gaining worldwide attention as a newly emerging bottom-up and top-down combined technique for novel nanomaterial synthesis, offering diverse applications including optics and biology [1,2,3,4]. Unlike the wet-chemistry synthesis method, where particle growth terminates when the seed concentration drops below the critical concentration [27], the particle growth can be sustained during the entire period of LAL, because every pulse ablation produces new seeds for particle growth. This is the reason novel football-like AgGe microspheres [17], with sizes up to 7 μm, can be obtained by LAL. No attempt has been made to study the growth of the metallic particles just after laser irradiation, which occupies the dominant position in all three liquid-phase laser synthesis methodologies, LAL, laser fragmentation in liquids (LFL), and laser melting in liquids (LML) [1]

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call