Abstract
When designing the LED filament lamp device and driving circuit at the beginning, software simulation is an indispensable step. It is necessary to verify whether the circuit output results are consistent with the requirements through simulation. In this paper, first measure the volt-ampere characteristics of the actual 1W LED filament strip, and applied the six-segment linear approximation model method for Spice modeling. The simulated volt-ampere characteristics of the 1W model were consistent with the measured volt-ampere characteristics of the 1W LED filament strip. Then use the driver chip HV9910B to design the LED filament lamp switch constant current drive circuit. Combined with the piecewise linear equivalent method, 3W, 4W, 5W LED filament lamp loads are modeled, the detailed design process of the entire circuit is analyzed, and the output voltage, current, inductance output current, MOS output voltage and other parameters of the whole circuit are simulated and verified. The results show that the output voltages are 71V, 142V, 71V, and the output currents are 30.4mA, 20.7mA, 51.1mA respectively under the circuit topology of 3W, 4W, and 5W LED filament lamp. When the inductor current works in CCM mode, the duty cycle of MOS output voltage meets the requirements, and the circuit output results are consistent with the design requirements.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
