Spectroscopic and chemical investigations on volatile fission and activation products within the fuel-cladding interface of irradiated pressurised water reactor fuel rod segments

Abstract

Abstract. In Germany, the present waste management concept foresees the direct disposal of spent nuclear fuel (SNF) in deep geological repositories for high-level waste available by 2050, at best. Until then, SNF is encapsulated in dual-purpose casks and stored in dry interim storage facilities. Licenses for both casks and facilities will expire after 40 years following loading of the cask and emplacement of the first cask in the storage location. Yet, due to considerable delays in the site selection process and the estimated duration for construction and commissioning of a final repository of at least 2 decades, a prolonged dry interim storage of SNF is inevitable (ESK, 2015). Concerning these considerable timespans, integrity of the cladding is of utmost importance regarding the ultimately conditioning of the fuel assemblies for final disposal. Various processes strain the structural integrity of Zircaloy cladding during reactor operation and beyond such as delayed hydride cracking, fuel-cladding chemical interactions or irradiation damage induced by α-emitters present in the fuel pellet's rim zone (Ewing, 2015). Especially with higher burn-up, the gap between fuel and cladding closes and results in the formation of an interaction layer, in which precipitates of fission and activation products are present, displaying an interface for degradation processes. For chemical analysis and speciation of these agglomerates, Zircaloy-4 and SNF specimens were sampled from fuel rod segments irradiated in commercial pressurised water reactors during the 1980s. Zircaloy-4 specimens were taken from an UOX (50.4 GWdtHM-1) and mixed oxide fuel (MOX) (38.0 GWdtHM-1). In addition, SNF fragments were sampled from the closed gap of both fuel types to examine volatile activation and fission products, which had been segregated from the centre to the pellet periphery during irradiation and thus contribute to the possible chemically assisted cladding degradation effect of the precipitates within the fuel-cladding interface. Spectroscopic analysis of precipitates within the interface layer between fuel and cladding were performed by optical microscopy, X-ray absorption and X-ray photoelectron spectroscopy, as well as by energy-dispersive scanning electron microscopy. Moreover, the radionuclide inventory of the respective Zircaloy-4, fuel and interaction layers was determined using liquid scintillation counting, γ-spectroscopy, gas mass spectrometry, ion chromatography and inductive-coupled plasma mass spectrometry and compared to results received by MCNP/CINDER and webKORIGEN calculations. In this study, we provide results regarding the speciation and chemical composition of previously identified Cs-U-O-Zr-Cl-I bearing compounds found in the interaction layer of irradiated nuclear fuel and inventory analyses of radionuclides present therein, with particular emphasis on Cl-36 and I-129. Furthermore, the agglomerates within the fuel-cladding interface were characterised for the first time utilising synchrotron radiation-based Cl K-edge and I K-edge measurements, resulting in compounds with structural similarities to CsCl and CsI. The outcomes obtained from this study provide further insights into the complex chemistry within the fuel-cladding interface with respect to the aging management and integrity of SNF under the conditions of interim storage. In future studies we will examine whether the different compounds at the fuel-cladding interface have the potential to affect the mechanical properties of Zircaloy cladding.