Abstract
A new, simple, rapid and sensitive solid phase extraction procedure based on separation and preconcentration of trace levels of allura red in water samples on MCI GEL CHP20P column system has been established. Optimal analytical conditions including pH, amount of allura red, flow rates of sample and eluent solutions, resin amount, sample volumes, etc. were investigated. The interference effect of some cations and anions was also studied. Preconcentration factor was found as 250. The detection limit (3 sigma) of the reagent blank for allura red was 2.35μgL−1. The determination of allura red levels in samples was performed by using spectrophotometry at 506nm. The relative standard deviations of the procedure were below 7%. The validation of the presented procedure was performed by the method of standard addition. The procedure was successfully applied to the determination of trace levels of allura red in tap water and waste water samples.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
