Abstract
Color reproduction of an anterior tooth requires advanced laboratory techniques, talent, and artistic skills. Color matching in a laboratory requires the successful transfer from in vivo with careful considerations. The purpose of this study was to monitor and verify the color reproduction process for an anterior all-ceramic crown in a laboratory through spectrophotometric measurements. Furthermore, a crown insertion process using composite luting cements was assessed, and the final color match was measured and confirmed. An all-ceramic crown with a zirconia ceramic coping for the maxillary right central incisor was fabricated. There was a significant color difference between the prepared tooth and the die material. The die material selected was the closest match available. The ceramic coping filled with die material indicated a large color difference from the target tooth in both lightness and chromaticity. During the first bake, three different approaches were intentionally used corresponding with three different tooth regions (cervical, body, and incisal). The first bake created the fundamental color of the crown that allowed some color shifts in the enamel layer, which was added later. The color of the completed crown demonstrated an excellent color match, with Delta E 1.27 in the incisal and 1.71 in the body. In the cervical area, color match with Delta E 2.37 was fabricated with the expectation of a color effect from the underlying prepared tooth. The optimal use of composite luting cement adjusted the effect from the underlying prepared tooth color, and the color match fabricated at a laboratory was successfully transferred to the clinical setting. The precise color measurement system leads to an accurate verification of color reproduction and its transfer. CLINICAL SIGNIFICANCE The use of a dedicated dental spectrophotometer during the fabrication of an all-ceramic crown allows the dentist and the laboratory technician to accurately communicate important information to one another about the shade of the tooth preparation, the shade of the contralateral target tooth, and the influence of luting cement on the final restoration, thereby allowing the technician better control over the outcome of their tooth color matching efforts and the final color match of an all-ceramic restoration.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have