Abstract
A spectral splicing method is proposed for an optical frequency domain reflectometry (OFDR) sensing system using a distributed Bragg reflector (DBR) laser. An external cavity tunable laser (ECTL) is used in a conventional OFDR sensing system. There are no reports to our knowledge about using a DBR laser as the light source for an OFDR sensing system. A DBR laser has the advantages of small size, no mechanical scanning, easy integration, and low cost. However, due to the mode hopping, the wavelength can only be continuously tuned in the range of about 1 nm. The spectral splicing method was used to splice 39 partially overlapping Rayleigh scattering signals into a continuous signal with wavelength of 35.174 nm. Distributed optical fiber strain sensing with 5 mm spatial resolution is realized. The strain range is ±2500µε, and the maximum error of the measured strain is 9.91 µε.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
