Abstract
Increase in speeds of modern railway trains is usually accompanied by higher levels of generated ground vibrations. In the author's earlier paper [V.V. Krylov, Applied Acoustics, 44, 149–164 (1995)], it has been shown that especially large increase in vibration level may occur if train speeds v exceed the velocity of Rayleigh surface waves in the ground cR., i.e., v > cR. Such a situation might arise, for example, with French TGV trains for which speeds over 515 km/h have been achieved. The present paper investigates the effect of geological layered structure of the ground on ground vibrations generated by high-speed trains. It is shown that, since Rayleigh wave velocities in layered ground are dispersive and normally increase at lower frequencies associated with deeper penetration of surface wave energy into the ground, the trans-Rayleigh condition v > cR may not hold at very low frequencies. This will cause a noticeable reduction in low-frequency components of generated ground vibration spectra. Theoretical results are illustrated by numerically calculated frequency spectra of ground vibrations generated by single axle loads travelling at different speeds and by TGV or Eurostar high-speed trains.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Low Frequency Noise, Vibration and Active Control
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.