Specifics of change in the surface area of amorphous poly(vinyl chloride) during its inelastic deformation

Abstract

A direct microscopic observation procedure was used to study the processes of deformation and shrinkage of poly(vinyl chloride) above its glass transition temperature. Prior to stretching or contraction of the polymer, its surface was decorated with a thin (10–15 nm) metal layer. As a result of subsequent deformation (shrinkage), the decoration underwent structural rearrangements, which were detected by means of direct microscopic examination. These rearrangements contain information on the mechanism of deformation of the polymer substrate. In particular, the procedure makes it possible to characterize the process of development of the interface in the polymer during deformation and the reverse process of interface contraction during the shrinkage of the material. It was found that, in the case of an increase in the interfacial area, its growth is accompanied by a growth in imperfection of the polymer surface layer. These defects can concentrate mechanical stress, thus strongly affecting the fragmentation of the metal decoration on the polymer surface. It was shown that the surface defects could be eliminated by annealing of the polymer above its glass transition temperature. The introduction of a plasticizer that decreases the glass transition temperature below the deformation temperature likewise prevents the development of these defects during an increase in the surface area of the polymer in the process of its inelastic deformation.