Abstract

This study reports on the impact of repeated powder recycling on the degradation of low alloy steel powder in Laser Powder Bed Fusion. The average powder particle size increased slightly upon recycling due to powder agglomeration and the presence of spatters and other ejecta from the process zone. The oxygen content showed a continuous growth after each recycle, while the other chemical elements of the recycled powder remained largely unchanged. A map of ejecta classification is presented, featuring various ejecta types formed during laser processing. Ejecta of increased diameter and different shapes were observed in the recycled powder, using high-speed imaging and Scanning Electron Microscopy. The ejecta were collected after each powder recycle to enable the calculation of the ejecta mass generated during the process. The result showed a direct correlation between oxygen content in the powder and spatter/ejecta formation with the number of recycling events. It is likely that the increase in oxygen contributes to powder spattering.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.