Abstract

Pollution haze is a frequent phenomenon in the North China Plain (NCP) appearing during winter when the aerosol is affected by various pollutant sources and has complex distribution of the aerosol properties, while different aerosol components may have various critical effects on air quality, human health and radiative balance. Therefore, large-scale and accurate aerosol components characterization is urgently and highly desirable but hardly achievable at the regional scale. In this respect, directional and polarimetric remote sensing observations have great potential for providing information about the aerosol components. In this study, a state-of-the-art GRASP/Component approach was employed for attempting to characterize aerosol components in the NCP using POLDER/PARASOL satellite observations. The analysis was done for January 2012 in Beijing (BJ) and Shanxi (SX). The results indicate a peak of the BC mass concentration in an atmospheric column of 82.8 mg/m2 in the SX region, with a mean of 29.2 mg/m2 that is about four times higher than one in BJ (8.9 mg/m2). The mean BrC mass concentrations are, however, higher in BJ (up to ca. 271 mg/m2) than that in SX, which can be attributed to a higher anthropogenic emission. The mean amount of fine ammonium sulfate-like particles observed in the BJ region was three times lower than in SX (131 mg/m2). The study also analyzes meteorological and air quality data for characterizing the pollution event in BJ. During the haze episode, the results suggest a rapid increase in the fine mode aerosol volume concentration associated with a decrease of a scale height of aerosol down to 1500 m. As expected, the values of aerosol optical depth (AOD), absorbing aerosol optical depth (AAOD) and fine mode aerosol optical depth (AODf) are much higher on hazy days. The mass fraction of ammonium sulfate-like aerosol increases from about 13% to 29% and mass concentration increases from 300 mg/m2 to 500 mg/m2. The daily mean PM2.5 concentration and RH independently measured during these reported pollution episodes reach up to 425 g/m3 and 80% correspondingly. The monthly mean mass concentrations of other aerosol components in the BJ are found to be in agreement with the results of previous research works. Finally, a preliminary comparison of these remote sensing derived results with literature and in situ PM2.5 measurements is also presented.

Highlights

  • In recent years, haze pollution has drawn growing worldwide concerns, especially in developing countries

  • GRASP/Component approach was applied to processing POLDER-3 data over the selected studied regions

  • It should be noted that considering optical characteristics such as AODf and absorbing aerosol optical depth (AAOD) is for the air pollution characterization

Read more

Summary

Introduction

Haze pollution has drawn growing worldwide concerns, especially in developing countries. Haze pollution is frequently observed during winter in North China. An increasing number of studies focused on haze events associated with significant impacts on air quality, human health and global climate change [2,3,4]. It is well known that secondary inorganic aerosols, such as SO42− , NO33− , NH44+ and organic aerosol (OA) are the dominant air pollutants in hazes [5,6]. The primary aerosol or precursor can react to form a secondary aerosol which is the main component of PM2.5 under certain environmental conditions [7]. The research on aerosol components is the key to revealing the forming mechanism of haze [2]

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call