Abstract
Microplastics are a widespread environmental contaminant that raises serious concern for aquatic organisms. Hence, the present study was conducted to investigate the spatial and seasonal variation of microplastics, their characteristics, polymer types and the risk assessment caused by the microplastics in six sampling sites along the Thoothukudi region. The average microplastic abundance ranged from 32 ± 26 to 232 ± 229 items/kg and 54 ± 41 to 619 ± 377 items/l in sediment and surface water, respectively, and they exhibited a significant spatial difference among the sampling sites. The microplastic abundance also showed a significant difference among the seasons with the monsoon significantly recording the highest mean microplastic abundance in sediment (160 ± 130 items/kg) and surface water (454 ± 374 items/l). In sediment and surface water, fragment (sediment: 52.72%, surface water: 40.89%), 0.5-1mm (sediment: 43.96%, surface water: 31.11%) and blue-coloured (sediment: 52.33%, surface water: 41.85%) microplastics were dominant with no significant difference both spatially and seasonally. Polyethylene, the dominant polymer, was observed in both the sediment and surface water, accounting for about 47.58% and 49.83%, respectively, and it showed no significant difference among the selected sites. This signifies that they are homogenously distributed along the coast and further suggests that these particles persisted in the sediment and surface water for a longer period of time. The results of the polymer hazard index show that the sediment (PHI = 1181.63) and surface water (PHI = 1018.66) were severely contaminated (hazard level V) with microplastic polymers such as PE, PP, PS, PET and PA. It was also found that the degree of the microplastic contamination in sediment (PLI = 3.57) and surface water (PLI = 3.84) was lower (hazard level I). The overall risk index (RI) for sediment (253.48) and surface water (444.74) falls under the higher risk category. From the correlation analysis, a significantly positive relationship was observed between microplastics in sediment and surface water based on each classification (abundance, shape, size, colour and polymer). This suggests that microplastics rejoin the water column from the sediment through resuspension, which occurs due to the circulation, tides and sedimentation rate. This might be the reason for the higher microplastic abundance in the surface water than in the sediment. As a result, proper management measures to reduce plastic waste disposal in the marine environment should be implemented to lessen the effects of microplastics on marine biota and on public health.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.