Abstract
Spatial light modulators (SLMs) designed to replace photomasks for optical lithography have been designed, fabricated, and tested. These microelectromechanical devices are fabricated with alternating polycrystalline Si and sacrificial SiO2 layers that are patterned by a 193nm wavelength scanner to dimensions as small as 150nm. Aerial image simulations were used to define the mechanical requirements of the devices. Piston motion of electrically actuated devices was measured with an optical profilometer. The measurements were fit to a simple equation to within 1nm precision, which is adequate for defining 50nm features lithographically. Transient response measurements show that one version of the SLM responds to actuation as quickly as 20μs, fast enough for current 193nm wavelength excimer laser sources.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
