Abstract
AbstractBACKGROUND: Four common free radical photoinitiators were evaluated for use in thick photopolymerizations illuminated with a medium‐pressure 200 W mercury–xenon arc lamp and a high‐intensity 400 nm light‐emitting diode (LED) lamp. For each photoinitiator/lamp combination, the spatial and temporal evolution of the photoinitiation rate profile was analyzed by solving the set of differential equations that govern the light intensity gradient and initiator concentration gradient for polychromatic illumination.RESULTS: The simulation results revealed that two of the four photoinitiators evaluated were ineffective for photoinitiating thick polymer systems. The photoinitiator bis(2,4,6‐trimethylbenzoyl)‐phenylphosphine oxide, in combination with the 400 nm LED lamp, was shown to be the most efficient photoinitiator/light source combination for photoinitiation of thick systems.CONCLUSION: The results show that some photoinitiators commonly used for photopolymerization of thin coatings are ineffective for curing thick systems. LED light sources provide advantages over traditional mercury lamps, and may have tremendous potential in the effective photoinitiation of thick polymer systems. Copyright © 2008 Society of Chemical Industry
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
