Abstract
During sintering of blended powders by spark plasma sintering (SPS), short sintering times are opposed by the requirement of sufficient diffusion times to obtain chemical homogenization. In this study, commercially blended Al-alloy powder Alumix 431D was sintered by SPS at 425°C for various sintering times. Microstructure analysis and mechanical properties of the consolidated components in the T1 and T6 states were evaluated. Densities between 97.5 and 99.7%TD were obtained across all hold times. After sintering for 60min, microhardnesses of 91±8 and 143±6HV were attained in the T1 and T6 conditions, respectively. The T1 samples had a flexural strength of 659±37MPa and a flexural strain of 5.7±0.3%, compared to 552±43MPa and 3.8±0.2% in the T6 temper. The mechanical properties of the T6 components were lower than those found in the literature. Extensive solution heat treatments of 2 and 4h were performed prior to aging.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
