Southern Juan De Fuca Ridge and Escanaba Trough, Gorda Ridge: Comparison of Hydrothermal Deposits in Sediment-Free and Sediment-Covered Ridge Settings: ABSTRACT

Abstract

Southern Juan De Fuca Ridge (SJDF) is a low-relief, sediment-starved ridge axis that has a total opening rate of 6 cm/year and is characterized by lobate and brecciated sheet flows and pillows of MORB composition. Sulfide deposits form at {approximately}2,200 m water depth and are concentrated within a narrow graben centered within the ridge axial valley. Solitary and coalesced chimneys (0.25 to 12 m high) rise directly from the basalt basement and are composed predominantly of Zn sulfide accompanied by Fe and Cu-Fe sulfide and traces of Pb sulfide. Anhydrite occurs as a minor phase in some chimneys. Sulfide chimneys were formed by rapid-venting of high temperature ({approximately}285{degree}C) fluids. These acidic fluids (pH {approximately}3.5) are enriched in Cl, Na, and Ca and are depleted in Cu and Zn. In contrast to SJDF, Escanaba Trough (ET) is spreading at {approximately}2.3 cm/year and has the high relief and axial graben morphology typical of the slow-spreading Mid-Atlantic Ridge. The floor of the axial valley is buried by up to 500 m of clay and terrigenous silt. Rare basement exposures reveal unbrecciated sheet flows and pillow basalts of MORB composition. Large chimney-topped sulfide mounds up to 20 m high and hundreds of meters inmore » extent occur at {approximately}3,250 m water depth at the base of sediment hills; sulfide veins, small chimneys, and clastic deposits occur on, and within, the sediment between hills. Two distinct sulfide types occur at ET. Pyrrhotite-rich sulfide is enriched in Fe, Cu, and As and is associated with low-velocity venting of warm (<220{degree} C) alkaline (pH {approximately}5.4) fluids that are currently depositing anhydrite and barite sinter deposits on top of the sulfide mounds.« less