Sorption of Sb(III) and Sb(V) to Goethite: Influence on Sb(III) Oxidation and Mobilization

Abstract

Antimony is an element of growing interest for a variety of industrial applications, even though Sb compounds are classified as priority pollutants by the Environmental Protection Agency of the United States. Iron (Fe) hydroxides appear to be important sorbents for Sb in soils and sediments, but mineral surfaces can also catalyze oxidation processes and may thus mobilize Sb. The aim of this study was to investigate whether goethite immobilizes Sb by sorption or whether Sb(III) adsorbed on goethite is oxidized and then released. The sorption of both Sb(III) and Sb(V) on goethite was studied in 0.01 and 0.1 M KClO4 M solutions as a function of pH and Sb concentration. To monitor oxidation processes Sb species were measured in solution and in the solid phase. The results show that both Sb(III) and Sb(V) form inner-sphere surface complexes at the goethite surface. Antimony(III) strongly adsorbs on goethite over a wide pH range (3-12), whereas maximum Sb(V) adsorption is found below pH 7. At higher ionic strength, the desorption of Sb(V) is shifted to lower pH values, most likely due to the formation of ion pairs KSb(OH)6 degrees. The sorption data of Sb(V) can be fitted by the modified triple-layer surface complexation model. Within 7 days, Sb(III) adsorbed on goethite is partly oxidized at pH 3, 5.9 and 9.7. The weak pH-dependence of the rate coefficients suggests that adsorbed Sb(III) is oxidized by 02 and that the coordination of Sb(III) to the surface increases the electron density of the Sb atom, which enhances the oxidation process. At pH values below pH 7, the oxidation of Sb(III) did not mobilize Sb within 35 days, while 30% of adsorbed Sb(III) was released into the solution at pH 9.9 within the same time. The adsorption of Sb(III) on Fe hydroxides over a wide pH range may be a major pathway for the oxidation and release of Sb(V).