Abstract
The aim of this study is to demonstrate the potential of oak wood charcoal (WC) and oak wood charcoal ash (WCA) as a low-cost adsorbent for environmental protection applications of Cr(VI) ion. The influence of contact time, solution pH, initial metal concentration, amount of adsorbent and ionic strength on the removal of Cr(VI) ion was studied. The adsorption of Cr(VI) with (WC) and (WCA) was investigated in a batch arrangement. The Cr(VI) ions sorbed onto the adsorbents were determined by a UV–Visible Spectrophotometer. The sorption of Cr(VI) on the adsorbent surface depends strongly on the pH and Cr(VI) ion-sorption increased with a decreasing pH until pH 2 and increase in the concentration of this metal in solution phase. The adsorption of Cr(VI) was higher between pH 2.0 and 2.5 for both adsorbents. The Freundlich adsorption isotherm was used to describe observed sorption phenomena. The maximum adsorption capacity of 30.10 mg of Cr(VI)/g for (WC) and 46.17 mg of Cr(VI)/g for (WCA) was obtained at pH of 2 and 2.5 respectively.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
