Sorption and diffusion of oxygen in plasticized ethyl cellulose films of varying degrees of substitution

Abstract

Plasticized films cast from ethyl cellulose were examined to evaluate the effect of the degree of substitution, DS, and the plasticizer content on the sorption and diffusion of oxygen. Sorption and permeation measurements were performed over a temperature range of 25–65°C on three different types of ethyl cellulose in the DS range 1.7–2.5 that had been plasticized with organic esters of comparatively low molecular weight. Sorption coefficients were determined by the pressure decay method, and permeability coefficients were measured independently according to ASTM D-1434-66. The diffusion coefficients were calculated assuming Fickian transport, and were compared to the values directly obtained from the evaluation of the sorption kinetics. The permeability coefficient indicates that there is a significant improvement of the barrier properties of the materials when the DS is reduced and when the plasticizer content is at the absolute minimum required. It was found that the variation in the magnitude of the permeability coefficient is related to the value of the diffusion coefficient, which is governed by the chemical composition of the mixtures. In contrast, the solubility of oxygen was determined by the physical state of the polymer matrix and increased rapidly at temperatures significantly below the glass transition temperature. Using an ergodic model, the diffusion coefficients obtained were related to the size distribution of microvoids in the materials and relative values for the diffusion coefficient were computed as a function of DS and temperature. The model calculates the concentration (number per volume) of voids that are large enough to be occupied by a penetrant molecule. It was assumed that the unoccupied volume fraction as a function of the cohesive energy density follows a Boltzmann distribution. The cohesive energy density and the unoccupied volume fraction of the polymer-plasticizer mixtures were calculated by fitting the Simha-Somcynsky equation of state to pressure-volume-temperature data. © 1997 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys, 35: 639–653, 1997