Sorption and diffusion of alcohols in amorphous polymers

Abstract

AbstractThe effects of polymer composition and penetrant molecular size on the solubility and diffusivity of alcohol vapors in a series of well characterized isoprene‐methyl methacrylate copolymers and their corresponding homopolymers has been investigated at room temperature. The rate of sorption behavior changes progressively from Fickian to non‐Fickian, to Case II to “Super Case II” transport with increasing methyl methacrylate (MMA) content in the polymers. The equilibrium solubility of the alcohols increases linearly with increasing penetrant molecular size for polymers which are above their glass transition temperature and decreases for polymers which are below their Tg. The solubility also initially increases as an approximately linear function of MMA content in the copolymers. At about 55 mole percent MMA, the sorbed concentration either levels off or passes through a maximum depending on the size of the penetrant. The apparent “diffusion coefficients” (D) decrease with increasing molecular volume of the penetrants. An exponential dependence was found between these two variables for PMMA. These “diffusion coefficients” also decrease exponentially with increasing MMA content in these polymers. However, at 55 mole percent MMA the copolymer undergoes a rubber to glass transition at the temperature of the experiments. On this basis, it is suggested that the hindered chain segmental motion contributes to the sorption process in addition to strictly thermodynamic considerations. Free volume theory can be used to explain the mechanism of diffusion through the rubbery polymers while the “hole” theory can be applied to explain the transport of the penetrants through the glassy polymers.