Abstract
The sorption and desorption characteristics of methyl bromide (MB) were determined during and after fumigation of recently harvested pine (Pinus radiata D. Don) logs. The effects of dose (48 or 120 g m-3 ), degree of bark cover (0, 50 or 100%) and end-grain sealing (sealed or unsealed) on sorption and desorption were determined over time. Sorption of MB was proportional to the dose applied and dependent on the amount of end-grain sealed. After 16 h, an average of 70.7 ± 2.5% of the initial concentration remained in the treated space when end-grains were sealed, whereas only 47.3 ± 2.5% remained when unsealed. During aeration, MB was released from logs, initially ranging from 2.8 to 8.8 g · h m-3 , depending on the treatment. The rate of desorption quickly decreased during aeration. The surface area of a log is the most important factor influencing MB sorption and desorption rates, with greater surface area resulting in greater (de)sorption rates. Sorption data can now be combined with insect toxicity data to estimate a minimum effective dose of MB for further evaluation, while desorption data can be combined with fumigant plume modelling to assess worker safety. © 2016 Society of Chemical Industry.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.