Abstract

Per- and polyfluoroalkyl substances (PFASs) are anthropogenic amphipathic heat-resistant materials found in some household products and Aqueous Film-Forming Foams (AFFFs) used to extinguish hydrocarbon fires. There is a critical need for developing destructive technologies for the treatment of PFAS-impacted waters because several PFASs are classified as probable carcinogens and endocrine disruptors. We tested the destruction of 7 individual PFASs, a mix of 24 native PFASs (24Mix), and samples of AFFF and concentrated Investigation Derived Waste (IDW) by high-frequency ultrasound (700 kHz – 1040 W) in deionized water, groundwater containing low total dissolved solids (TDS) (388 mg L−1), and high-TDS groundwater (10.2 g L−1). This study demonstrated the degradation of novel PFASs, hexafluoropropylene oxide dimer acid (HFPO-DA) and 6:2 fluorotelomer sulfonamidoalkyl betaine (6:2 FTAB), with near-stoichiometric fluoride release. The salts and surfactants affect the air-water partitioning coefficients of PFASs and their availability at the ultrasonic cavity, thereby affecting the degradation rates. The degradation rates of sulfonates and short-chain PFASs were 30% to 60% higher in low TDS groundwater than those in deionized water, while the rates were lower in high TDS groundwater. The degradation rates of sulfonates in AFFF were 40% to 60% higher as compared to the 24Mix. The treatment of concentrated, high-TDS IDW resulted in significant defluorination of 41 PFASs, consuming 3 kWh g−1 – 76 kWh g−1 whereas dilute AFFF degradation utilized 5900 kWh g−1. The results inform important parameters for designing and operating ultrasonic reactors for the degradation of PFASs and verify that sonolytic treatment of concentrated PFAS mixtures and AFFF IDWs can effectively degrade and defluorinate PFASs without the formation of disinfection by-products.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call