Some metallurgical aspects of steelmaking with sponge iron in electric arc furnaces

Abstract

Test charges containing sponge iron proportions varying from 38.7–95.4 wt% of the metallic input were melted in a UHP electric arc furnace with a design capacity of 70 tons per heat. After melting started, samples of molten metal and the corresponding slag were taken simultaneously at different time intervals and analysed. The time dependence of the chemical composition of the metal and slag as well as the variation of the temperature of the melt with time are given. Thermodynamic calculations using different methods for finding the activity of ferrous oxide show that there is a linear relationship between a(FeO) and the total ferrous oxide content in the slag. It is also found that the total ferrous oxide content in the slag and the oxygen concentration in the metal vary linearly with the iron proportion from sponge iron in the metallic input. The activity of ferrous oxide decreases with increasing slag basicity due to the formation of calcium ferrites. The relationship between the oxygen concentration and the reciprocal of the carbon content in liquid steel is almost linear. A formula showing the influence of some important factors on the oxygen content in molten steel is given.The effect of sponge iron on the sulphur concentration in the steel is also investigated. The present results indicate that the sulphur content in the steel can be reduced from 0.02 to 0.004 wt% by increasing the iron proportion from sponge iron in the metallic input from 35 to 95 wt %. Using the boundary layer diffusion model, it is found that the rate of decarburization of a steel bath is enhanced by increasing the sponge iron proportion in the metallic input. The activation energy of the decarburization reaction is found to be 56.9 kJ/mol and the mass transfer coefficient of carbon has a value of 0.0161 cm/s at 1 600°C. In a way similar to that used for decarburization, it is also found that the rate of oxidation of manganese dissolved in the bath is enhanced by increasing the sponge iron proportion in the metallic input.