Abstract

The surface microrelief of carbon steel after ultrasonic finishing treatment was studied using a Micro Measure 3D Station three-dimensional contactless profilometer. The effect of the parameters of the initial surface on the microrelief of the obtained surface was considered. Some features of the formation of a microrelief under the regimes of hardening and finishing hardening treatment were described. To remove rehardening traces on the surface layer, introduction of a geoactivating material into the zone of treatment was proposed.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.