Abstract

AbstractTwo‐ and three‐phase systems have been studied using particles that are water‐wetted and denser than water and with similar sized, small floating particles, both wetted and non‐wetted. The parameters investigated have been the agitator speed required to disperse the different types of particles under sparged and non‐sparged conditions and rates of gas‐liquid mass transfer. With the wetted, dense particles, only at concentrations of > ∼20% w/w did the kLa fall significantly (by ∼20 to 30%) whilst solid suspension followed the trends of earlier work. With the less dense particles, even with < ∼1% w/w that were not wetted, it was very difficult to disperse them throughout the liquid phase, though up‐pumping impellers were more effective than radial. In addition, bubble size significantly increased and kLa fell by a factor of 2 to 3. With the wetted, less dense ones up to 2% w/w, uniform dispersion was achieved even at much lower speeds and kLa did not change compared to the case without solids.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.