Solvent-free processes to polyurea elastomers from diamines and diphenyl carbonate

Abstract

Two solvent-free processes without using volatile organic chemical (VOC) for making polyurea elastomers have been successfully developed from diamines and diphenyl carbonate (DPC) to meet stringent public demands for a high standard green alternative Anastas and Eghbali (Chem Soc Rev 39 (1):301–312, 2010). In this new non-isocyanate route (NIR) which is an improvement over our previous process to polyurea elastomers, molten DPC are utilized as the carbonylation agents, where DPC reacts sequentially with 1,6-hexanediamine (HDA), polyether diamines of 2000 molecular weight and short chain diamines such as isophorondiamine (IPDA) or 4,4′-diaminodicyclohexylmethane (H12MDA). No solvent was added in the synthesis of these new non-solvent polyurea. Alternatively, the above process was modified with an 3 % addition of a water dispersant such as 3-[(2-aminoethyl)amino]-1-propane sulfonic acid sodium salt (ESA) to make waterborne polyurea elastomers to facilitate the mixing in the preparation and in the film-making steps for the final products. In both solvent-free processes, the long-chained polyether diamine and the phenol generated from the displacement reaction of diphenyl carbonate were utilized as diluents to lower the viscosities of the reaction mixtures. Unexpectedly, ultra high molecular weight products were resulted particularly for the waterborne polyurea products measuring in excess of 1,000,000 g/mol in some cases. All samples were characterized by FT-IR, H-NMR, TGA, DSC, AFM and GPC. Since the polymers were prepared under mild conditions in absence of a VOC solvent, the new products were found to mostly exist in highly phase-segregated states, exhibiting high heat-resistant temperatures with Td(5%) of well over 300 °C with high elongation (>600 %) for the optimized products. Thus, this solvent-free syntheses and environment-friendly polyurea products should find usefulness in many practical applications.