Abstract

Solvent emissions is a serious problem in the industrialization of the amine scrubbing process. To design pollutant control equipment for a 2 million tons/year CO2 capture plant, a bench and a pilot facility were tested to investigate the aerosol emissions. And three Aspen models were built to study vapor emission and design emissions control measurement. The emissions assessment showed the treated flue gas after the absorber was about to discharge 1078 mg/Nm3 aerosol-type solvent and 1055 mg/Nm3 vapor-type solvent. The experimental results of particle size distribution indicated that improving the growth of the submicron droplets before the water wash and demister was the key to control aerosol emissions. Three control methods were compared by simulation, the best control measure was the combination of dry bed and water wash section, and the drain-out water is feed to the top of the dry bed. Considering the economy and control efficiency, the packing height of the water wash section is 2.5 m, and the scrubbing flow rate is 5000 Nm3/h. The extra cooling for the dry bed is not necessary and uneconomic. Under this countermeasure, the vapor emissions solvent is as low as 1.27 mg/Nm3 without additional freshwater for the water wash section.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.