Abstract
The natural aging (NA) response of a commercial Al–Zn–Mg alloy has been tracked to investigate the effects of solute clusters on its mechanical properties. It has been observed that the increase of yield strength during NA is not accompanied by the degradation of uniform elongation due to the simultaneously enhanced strain hardening ability. As a consequence, the Al–Zn–Mg alloy with dense solute clusters shows a comparable yield strength, better strain hardening ability and uniform tensile strain relative to its artificially aged counterparts containing precipitates. This positive effect of solute clusters on strain hardening has been systematically studied by tracing the microstructure evolution during deformation through synchrotron X-ray diffraction and atom probe tomography. We found that the dislocation multiplication dominates over the entire deformation process until failure in NA alloys; however, no effect of solute clusters on the dislocation density evolution can be identified. On the other hand, solute clusters themselves dramatically evolve, showing a dissolution-to-coarsening transition during deformation, which can be understood on the basis of a kinetic model. The experimental evidence strongly suggest that the dislocation storage and strain-induced evolution of solute clusters are insufficient to account for the observed high strain hardening rate, and the contribution from other possible mechanisms are estimated in a semi-quantitative manner.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have