Abstract
This paper proposes a modular pulsed power modulator (PPM) with a short pulse width and high repetition rate for pulsed lasers. The presented PPM is based on the modular structure to use semiconductor switches with low voltage ratings since these switches have fast switching speed which is an essential requirement to generate short pulses. In addition, to make a short gate signal which is also needed to generate short pulses, a gate driver circuit which applies positive and negative voltages asymmetrically is proposed. Moreover, a heatsink structure to minimize the parasitic capacitances is presented for the high repetition rate. Furthermore, a DC-DC converter for the modular PPM is developed, which connects transformers in parallel at the primary side to achieve voltage balance without any compensation circuit. Experimental results from a 5 kV PPM with the pulse width below 20 ns and repetition rate of 1 MHz are presented to verify the proposed works.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
