Solid‐phase preparation of protein complexes

Abstract

Protein-protein conjugation is usually achieved by solution phase methods requiring concentrated protein solution and post-synthetic purification steps. In this report we describe a novel continuous-flow solid-phase approach enabling the assembly of protein complexes minimizing the amount of material needed and allowing the repeated use of the same solid phase. The method exploits an immunoaffinity matrix as solid support; the matrix reversibly binds the first of the complex components while the other components are sequentially introduced, thus allowing the complex to grow while immobilized. The tethering technique employed relies on the use of the very mild synthetic conditions and fast association rates allowed by the avidin-biotin system. At the end of the assembly, the immobilized complexes can be removed from the solid support and recovered by lowering the pH of the medium. Under the conditions used for the sequential complexation and recovery, the solid phase was not damaged or irreversibly modified and could be reused without loss of binding capacity. The method was specifically designed to prepare protein complexes to be used in immunometric methods of analysis, where the immunoreactivity of each component needs to be preserved. The approach was successfully exploited for the preparation of two different immunoaffinity reagents with immunoreactivity mimicking native squamous cell carcinoma antigen-immunoglobulin M (SCCA-IgM) and alphafetoprotein-immunoglobulin M (AFP-IgM) immune complexes, which were characterized by dedicated sandwich enzyme-linked immunosorbent assay (ELISA) and immunoblot. Besides the specific application described in the paper, the method is sufficiently general to be used for the preparation of a broad range of protein assemblies.