Abstract
The aluminium oxide films on austenitic steel are prepared from sols of re-dispersed boehmite nano powders in water. After dip-coating of the sol, a heat treatment including drying, calcination and annealing in vacuum at temperatures up to 1100°C is performed to obtain crack-free coatings of a thickness up to 6 μm. XRD measurements detect α- and γ-alumina, a TiOx-phase at the metal/coating interface and a gradient of phase formation in the coating. The strong adhesion on the substrates is due to the layered assembly and gradient composition of the coating caused by an inter-diffusion of metal cations and oxygen in the metal/oxide interface during heat treatment. Residual stress measurements by X-rays result in compressive stresses of 2–4 GPa in the alumina coatings. The pin-on-disc test shows a remarkable improvement of wear resistance obtained by sol-gel coatings. The α-alumina content and the compressive stress of the coatings correlate with wear resistance of the coatings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
