Abstract
The physical characteristics, thermoelectric power, resistivity, specific heat conductivity, and the temperature difference between hot and cold junctions determine the efficiency of thermocouple materials. These data have been determined for Chromel P-constantan, bismuth alloys, and the intermetallic compound ZnSb, containing small amounts of added metals. The optimum characteristics of flat-plate type solar energy collectors have been evaluated in combination with thermocouples, designed for maximum energy conversion. Using flat-plate collectors with 2 glass panes, an efficiency of 0.63 percent was obtained with the ZnSb-type alloys in combination with a negative Bi-alloy. The commercially available ductile alloys Chromel P-constantan, produced ten times lower efficiency. Calculations indicate that the efficiency may be increased to 1.05 percent by using 4 panes of low-reflection characteristics. With solar energy concentrating means (lenses), the efficiency was increased to 3.35 percent, using the above mentioned best alloy combination. The maximum allowable cost of thermoelectric generators has been evaluated, by comparison with present methods of electric power generation. Solar thermoelectric generators may find useful application in the tropics, as they do not contain moving parts and require very little attention. Further development is needed to determine their economical value.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.