Abstract

The photocatalytic degradation of a sodium diclofenac (DCF) solution (10 mg/L) under simulated solar radiation was evaluated using a ZnO semiconductor modified by the incorporation of 10, 15, and 20 wt.% fluorine (ZnO-F10, ZnO-F15 and ZnO-F20). The ZnO-F catalysts were synthesized by the sol-gel method using zinc acetate as a precursor of zinc oxide and NH4F as a fluorine source. The photocatalytic performance of the F-doped ZnO material was compared to that of bare ZnO. The obtained photocatalysts were characterized using X-ray diffraction (XRD), Scanning electron microscopy with Energy dispersive spectroscopy (SEM-EDS) and X-ray photoelectron spectroscopy (XPS) techniques. The Brunauer-Emmett-Teller (BET) surface area, pH of zero charge (pHpzc), and band gap of the solids were also evaluated. An experimental Box-Behnken design combined with response surface methodology was applied to establish the optimal conditions for the photocatalytic degradation of the DCF solution. Complete DCF degradation, total release of chloride ions, and approximately 90% mineralization were achieved during degradation of the drug at an accumulated energy of 400 kJ/m2 under the optimized experimental conditions (1 g/L of ZnO-F20 catalyst with the pH of the DCF solution maintained at 6.5).

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.