Abstract
ABSTRACTThe poly-Si film was deposited by using the metal-induced growth (MIG) method on tungsten substrates. By making Au/n-Si Schottky photo-diodes, doping density effect was studied by using three different doping level Si sputtering targets. Increasing the Si target resistivities from 0.02Ω-cm to 50Ω-cm, open-circuit-voltage (Voc) decreased from 0.22V to 0.14V while short-circuit-current density (Jsc) increased from 1.55mA/cm2 to 2.42mA/cm2. C-V results revealed a high charge density in the device, which may be due to the oxygen thermal donor effects. Using an oxygen filter for the sputtering gas effectively reduced the charge densities and increased the Jsc value. The p/n junction solar cells were fabricated by using ion implantation at 1013∼1014cm−2 dose and 100∼200keV. The cells with wider emitter layer by double-ion implantation gave higher Jsc and Voc values. Passivation of the Si film by using hydrogenation improved the Jsc, Voc and spectral response of the solar cells.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.